Connecticut River Flood Damage
Water from a Connecticut River overflow is pumped out, the mud is removed and the structure is dried to readings before rebuilding.
Choose the service by where the water came from, not by the room it is in. The services below cover river and sewer water, supply leaks, winter damage and the drying that follows every kind of loss, and each page explains the first step.
Fastest: call (833) 490-5225. Or send this and we call you back.
Start with the source. A flood from the Connecticut River or a backed-up cellar drain calls for flood water extraction and, for sewage, sewer backup cleanup. A frozen pipe in an outside wall calls for frozen pipe thaw damage.
Once the water is out, the drying decides how long the work takes. Plaster, framing and brick are measured in place, and structural drying and dehumidification describes how readings set the finish point.
Water from a Connecticut River overflow is pumped out, the mud is removed and the structure is dried to readings before rebuilding.
Water that enters a cellar during a storm is pumped out, sorted by source and dried before the walls and floors go back on.
Standing water is pumped and vacuumed out of the building before drying starts, with silt removed as the level falls.
Sewage that backs up into a home is removed, the drains are cleared and every surface it touched is disinfected before drying begins.
A burst supply pipe is isolated, the water is removed and the wet materials are dried to readings before the walls close again.
Pipes that froze and split leak when they thaw, so the water is shut off, the wet walls are opened and the framing is dried to readings.
Melt water backed up behind an ice dam is traced into the ceilings and walls, the wet material is removed and the structure is dried.
A leak in a three-story wood-frame house runs down through every apartment, so the drying is planned floor by floor.
A leak that spreads across several apartments is traced to its source, the wet ceilings are opened and each unit is dried to readings.
Rain that enters through storm-opened roofs and windows is stopped, the wet materials are removed and the structure is dried to readings.
Walls, framing and subfloors are dried with dehumidifiers and air movers, tracked by moisture readings until each material reaches its dry target.
Mold that starts in wet framing and plaster is assessed, removed where it grows and prevented by drying the materials to their targets.
A leaking water heater is isolated, the water is pumped from the cellar and the floor and joists are dried to readings.
When a sump pump stops, the pit overflows into the cellar, so the water is pumped out, the pump is restored and the walls are dried.
A failed washer, dishwasher or refrigerator line is isolated, the water is removed and the kitchen or laundry floor is dried to readings.
Groundwater that enters a crawl space or rises through a slab is pumped and dried, with the joists, insulation and vents checked.
Flood water from a tropical storm or hurricane is pumped out, the silt is removed and the framing is dried to readings before rebuilding.
| Service | Typical range | Details |
|---|
Estimates only. Your price is confirmed on site before work starts. See the full price guide.
A crew is dispatched as fast as one is available, and you approve the estimate before any work starts.
Start with the source inside that unit. A failed fitting or appliance points to a leak service, but the walkthrough also covers every unit below, because water in a stacked building moves down.
Visible growth is assessed on the walkthrough and recorded with the drying readings. Work that involves removing growth is scoped separately in writing before it begins.
Often yes. A flood and a sewer backup in the same cellar are usually handled in one walkthrough, with each category recorded and each step approved in turn.