Why is drying measured instead of judged by eye?
A surface can look dry while the material behind it still holds moisture. Readings from a meter and a probe show what the eye cannot, and they set the point where the building is safe to close.
A wall or floor that appears dry may still have water in its core, especially in dense materials. Moisture meters and probes read the material itself, and the readings are compared with the baseline in unaffected areas.
The readings also protect the homeowner. A building closed while its framing still holds water can develop swelling, staining and mold inside the cavity, where no one can see the problem until it is expensive to repair.
What does a dehumidifier do that a fan cannot?
A fan moves air across a surface and speeds evaporation, but it does not remove the water from the air. A dehumidifier pulls moisture out of the air, which lets evaporation continue and keeps the room from re-wetting the materials.
In a closed room with fans running and no dehumidifier, the air quickly becomes saturated and drying slows. The moisture simply moves from the material to the air and back again, which is why fans alone often stall.
A dehumidifier lowers the humidity so the materials can release their water. The two machines together create a steady drying condition, and the balance between them is adjusted as the readings change.
Why do old houses dry differently?
Plaster, masonry and old timber hold water in different places and release it at different rates. A house built with those materials needs a plan that respects them rather than a generic setup.
Lath and plaster trap moisture between the plaster and the wood, and the plaster can bond to the framing so tightly that drying must be slow. Brick and stone absorb water and release it into the rooms over time, which can prolong the drying at the floor line.
Old framing is often denser than modern lumber, and the moisture can sit in the heart of a member. The crew measures these elements carefully and uses a longer schedule rather than forcing the drying to finish early.
What can go wrong if drying is rushed?
Rushed drying can crack plaster, cup floorboards, leave moisture in the framing and set up conditions for mold. The drying should follow the readings and not the calendar.
Heat and fast airflow can shrink wood and plaster too quickly, leaving gaps and cracks that show later. A room that dries too fast on the surface can still hold water in the core, and the closing of the walls then traps it inside.
The record of the drying is the protection against these problems. Each reading shows whether the room is moving toward its target at a safe rate, and the crew adjusts the equipment when a material changes too fast.
What affects how long the structure takes to dry?
The materials involved, the depth of the wetting, the room temperature and the number of cavities opened all change the timing. Each job has its own schedule, set from the first readings.
A wetting limited to a finished room with bare framing dries faster than one that soaked into plaster, masonry and a subfloor. The depth matters because water that has traveled into the core of a material takes longer to leave it.
In winter, a cold house is harder to dry because cold air holds less moisture, and the crew may need to warm the work area to get the drying to proceed. The equipment and the schedule are adjusted for the season and the building.