Why does groundwater rise under a house?
Groundwater rises when the soil around the house is saturated and the water table is high, and it can enter a crawl space or push up through a slab. The soil and the drainage around the foundation decide how much comes in.
Soil that holds water releases it slowly, and the pressure of that water can push through cracks, joints and the footing. A house on a low lot or a site with poor drainage is more exposed, because the water has fewer places to go than it would on a slope.
Seasonal high water and the soil at a given house decide how much water arrives beneath the floor. Both are read on site, since the ground can change over short distances.
Is a damp crawl space a health concern?
A crawl space that stays damp can produce mold, musty air and dust, and that air can move into the rooms above. A space with standing water and decaying material calls for a careful cleanup and drying.
Moisture in the space feeds mold on the joists and the insulation, and the spores can reach the living area through the floor. People with allergies or asthma often notice the effect first, and the smell is a warning worth taking seriously.
A crawl space that has been dried and has its moisture source controlled is much less of a concern. The crew records the readings and recommends a vapor barrier and drainage changes where they are needed, so the air above stays cleaner.
Should the vapor barrier be replaced?
A torn, lifted or saturated barrier usually cannot keep the soil moisture out and should be replaced once the space is dry. A barrier that is intact can stay, but its edges and seams should be checked.
A barrier that has been under water holds silt and debris, and it can trap moisture between itself and the soil. Removing it and laying a new barrier once the space is dry gives the soil a cleaner surface to release moisture from.
The new barrier should be sealed at the seams and at the foundation walls, and it should be sloped so water runs toward the drain or the pump rather than pooling. A contractor can install it after the crew confirms the space is dry.
What decides the scope of a crawl space or slab job?
The depth of water, the access, the material under the house and the number of joists affected all change the work. The scope is agreed with the homeowner once the space has been surveyed.
A crawl space with a few inches of water and a clear hatch is a shorter job than one where the water has reached the joists along the whole length of the house. The slow pace of drying in a confined space also adds to the time.
A slab with a leak at a crack or a drain is usually a smaller job than a slab that takes on water across its whole area. The crew tests the slab at several points and measures the framing above before deciding how far the drying must go.
How can a homeowner keep a crawl space dry?
Keep the gutters clear, direct downspouts away from the foundation, grade the soil to slope away from the house and keep the vapor barrier intact. A dehumidifier in the space can help when the ground is damp.
Water that runs off the roof and lands against the foundation is one of the most common sources of crawl space moisture. Extending the downspouts and checking the grade after a storm lowers the amount that reaches the soil beside the house.
Inspecting the vents and the hatch after heavy rain helps as well. A vent that is blocked or open to water should be repaired, and a dehumidifier can keep the air dry during the wet months when the soil cannot.