Why does one leak reach so many apartments?
A triple-decker is built as a stack, with the same wall lines, plumbing runs and floor framing repeated on each level. Water follows those lines down, so a leak in one unit has a clear path to the units beneath it.
The plumbing in a stacked house is often run in a shared chase, and the chase connects the bath and kitchen on each floor. A joint that fails on the top floor can send water down the chase and onto the ceiling of the apartment below before anyone in the upper unit notices.
Floor joists run across the building and continue through the walls, so water in one bay can move along the framing to the next unit. The path is not always straight down, which is why the crew looks at the whole structure and not only the floor below the leak.
How is drying planned across three units?
The drying is planned from the top floor down, with each unit given its own readings and equipment. The order matters, since drying a lower floor while the one above is still wet only refills it.
The crew sets a target for each material in each unit and records where the readings sit. A unit can look finished while its ceiling framing above is still wet, so the readings in the framing decide whether the unit is ready to close.
Equipment is moved as each unit reaches its targets. Dehumidifiers work the building in stages, and the crew keeps the doors and the stairway managed so that moisture from one floor does not travel into a unit that has already dried.
Who pays for the repairs when the tenants and the owner are both affected?
Responsibility depends on the lease, the owner's insurance and the source of the leak. The restoration crew documents which unit the water came from, which helps each party sort out its own share of the repair.
A leak that starts in a tenant's unit may involve the tenant's renter's insurance, while a failure in a shared line or a roof edge is usually the owner's responsibility. The record of the source and the path lets the parties see where each piece belongs.
Massachusetts tenants and owners should check their lease and their policy. The Massachusetts Division of Insurance Consumer Services handles consumer complaints about insurers, and the crew can provide the records needed for a claim without deciding who is at fault.
What makes a triple-decker job larger or smaller?
The number of units reached, the finishes in each apartment, the access to the cellar and attic and the age of the framing all change the work. The owner approves the scope with the crew before any unit is opened.
A leak that touched only the top unit and its ceiling is a smaller job than one that moved down all three floors. Each additional unit adds removal, drying and documentation, and each finished room adds the time needed to protect the belongings inside it.
Older framing and plaster add time as well. Lath and plaster behave differently from modern drywall, and they need slower and more careful removal. The crew walks the building with the owner before the work starts so the plan is clear for every unit.